UVB-76.NET4625 kHz USB
PRIMER: HF GEOLOCATIONMETHOD: TDOA / DFUPDATED REFERENCE

Shortwave Triangulation Primer: TDOA Hyperbolas & Ionospheric Corrections

Pinpointing a shortwave transmitter operating between 3 MHz and 15 MHz requires understanding how radio waves travel through both ground-wave and ionospheric sky-wave paths. Modern open receiver networks make Time-Difference-of-Arrival (TDOA) accessible to any researcher with an internet connection.

How TDOA Computes a Transmitter Fix

Suppose Receiver A and Receiver B both record the same HF signal with GPS-disciplined timestamps. Cross-correlating the complex IQ envelopes reveals a time lag Δt. Because radio waves travel at the speed of light (roughly 300 km/ms), a constant lag Δt defines a hyperbola of possible transmitter locations. Intersecting hyperbolas from 3 to 6 well-spaced receivers converges on the source region.

Receiver Geometry FactorGood SetupPoor Setup (High Error)
Angular SpreadReceivers surround target across 3+ quadrantsAll receivers clustered along one straight line
Signal BandwidthSSB voice, FSK bursts, or crisp tone transitionsUnmodulated continuous CW carrier (ambiguous phase lag)
Ionospheric ModeAll receivers on same single-hop F2 or ground waveMixed ground-wave + 2-hop sky-wave paths

Cross-Checking TDOA Against Known Reference Beacons

Before trusting a TDOA plot on an unknown signal, always run the exact same receiver set against a nearby known reference transmitter (such as CHU on 3330/7850 kHz, RWM on 4996 kHz, or European VOLMET stations). If the reference beacon lands within 30 km of its published coordinates, the current ionospheric height model is well calibrated.

Further Reading